Installation

Packaged pumping station installation in Surrey

Foul and surface water package pump stations, designed for the site, from a single house to a housing development or industrial yard — plus upgrades, refurbishment and sewage lifting stations.

A newly installed twin packaged pumping station set into a plant-room floor, with two circular chambers, lifting chains and junction boxes.

Foul water and surface water package pump stations

We supply and install packaged foul and surface water pumping stations, above or below ground, from small domestic chambers to larger stations on housing and commercial developments. Rainwater harvesting chambers and booster sets can be included where the scheme needs them.

Typical packaged GRP stations are offered with chamber diameters from 0.8 to 2.9 metres and vertical depths from 1 to 6.5 metres. Horizontal chambers can be made to the length the site needs. Pump arrangements are single or twin, running as duty only, duty/assist or duty/standby.

  • Control panels built to order in the UK, in IP55 mild steel enclosures, with pear-type float controls or ultrasonics.
  • A high-level alarm, with volt-free contacts for remote signalling, is standard on all systems.
  • Access covers from pedestrian rating up to D400, to suit the location.
  • Pumps from established municipal manufacturers, in 230 V or 400 V, with galvanised or ductile iron pipework and sewage-rated valves.
  • Bespoke tanks can be delivered to site within 72 hours. A Fast-Trak fit-out is available within 48 hours if required; additional charges may apply.

Stations are designed in accordance with the relevant standards, including BS EN 12050-1 for pumping installations in buildings and sites, BS EN 12056-4 for drainage inside buildings, BS EN 752-6 for drain and sewer pumping stations outside buildings, and Approved Document H1 on foul drainage.

Isolation and non-return valves on galvanised discharge pipework inside a packaged pumping station valve chamber.
Isolation and non-return valves on the discharge pipework — part of a packaged station that is designed as one working system.

Sewage lifting stations, upgrades and refurbishment

Not every site needs a new chamber in the ground. Basement bathrooms, plant rooms and buildings below the backflow level often need a sewage lifting station. Existing wet wells can often be refurbished rather than replaced.

Sewage lifting stations

Packaged lifting plant is used where untreated sewage cannot reach the public sewer by gravity, including lower-ground accommodation and buildings below the backflow level. We supply and install lifting stations as well as below-ground packaged chambers.

Pump station upgrades

Where a station is undersized, obsolete or constantly in alarm, we can assess the duty and recommend replacement pumps, a new control panel, telemetry, or a larger packaged chamber, rather than repeating the same repair.

Refurbishment

We refurbish existing stations — including older brick chambers — where replacement of the whole package is not the right answer. That can include pipework, valves, guide rails, pumps and the control kiosk.

We can supply only, or handle mechanical and electrical installation and commissioning, including rising mains and dial-out telemetry. Quotations are based on the site, the incoming flow, the discharge point and the relevant standards — not a one-size chamber. We do not publish a single installed price, because civils, incoming levels and rising-main length vary widely; a site review is the honest way to quote.

Installation across Surrey

New packaged stations are installed throughout the county, from domestic sewage pumping stations on private houses to development and industrial sites in Guildford, Woking, Epsom, Reigate and Redhill, Leatherhead and Dorking and Farnham and Camberley.

If you have drawings, invert levels or a specification, send them with the enquiry. If you do not, we can help work out the duty from a site visit. After handover, the same team can put the station on a planned servicing contract.